Paragon 25 Cabin 2008

PRICE £89,950

This is a very well looked after Paragon 25, of similar ‘cabin rib design’ to a Botnia Targa 27 or Axopar. Produced in Sweden, the hull and performance will be hard to beat plus this vessel was commissioned with the larger engine option, a D4-300. A capable boat to take you anywhere, anytime, viewing is well recommended since these do not come on the market often.

Boat Make: Paragon

Boat Model: 25 Cabin

Boat Length: 25 ft

Engine Power (hp):

Keel Type:

Hull Material: Fiberglass

LOA: 8.52 metres (27.9ft)

Beam: 3 metres (9.8ft)

Draft: 1 metre (3.2ft)

Displacement: 3500kg

Single Volvo Penta d4-300hp

Fuel type is diesel

Last serviced in August 2018

Roughly 350 engine hours 

Duo-props on the stern drive 

Fuel tank: 320 litres

Water tank: 40 litres

Single burner hob

Sink

 

2 berths in 1 cabin

forward "v" berth with infills to make a spacious double

Heads underneath centre cushion

 

"L" shaped seating with a drop down table

Fridge below helm seat

Side doors on the port & starboard side of the boat to give easy access to the side decks. theres also another sliding door at the back of the cabin

Over head hatches x2

Raymarine Radome

Vhf radio

fish finder

Chart plotter

Compass

Depth sounder

Searchlight

Shore power

batteries x3

Trim tabs

Bowthruster

Fenders

Ropes

Anchor (with chain and rope)

Stainless steel grab rails around the boat

 

 

Parkstone Bay Yachts provides the details of this vessel in good faith but cannot guarantee the accuracy of the information set out in these particulars, and do we warrant the condition of the vessel. The particulars are intended as a guide only and do not constitute a term of any contract. A prospective buyer is advised to check the particulars and specifications and where appropriate instruct his agents, or his surveyors, to fully inspect the vessel and/or to have a sea trial of the vessel. This vessel is offered subject to prior sale, price change, or withdrawal without notice.

Boat Enquiry

  • This field is for validation purposes and should be left unchanged.

Like? Share…